Quadro SW-Version 4.1.x Guia de Instalação descarregar pdf (Página 100)

Quadro Manual II: Administrator's Guide Quadro's Auto Attendant Services

QuadroISDN; SW Version 4.1.x 100

Incoming call to Auto Attendant Services or dial locally

Keys

Extensions Menu - establishing a connection to an extension on the called Quadro

(already in)

Call Relay Menu - mainly for external calls (IP/ISDN), local calls are allowed, too.

Service allows you to avoid hanging up and redo the entire dialing, if Quadro detects an error in the dialed number or

the user decides to cancel the call and start a new one: Entering the combination



the call will be interrupted and

the user will get an invitation to make a new one. This is applicable during dialing, after the ring tone has started, and

after the call has been established.

c

“



” digit combination is

applicable:

• During the dialing,

• After ring tones start,

• After call establishment.

Under the following restrictions:

• This feature can be used when accessing the AA from the PSTN line to

make IP or local calls

• This feature can be used when calling to PSTN through the AA

• This feature is not available on the second Quadro Auto Attendant (calling

from one Auto Attendant to another)

Remote Configuration Menu – allows remote enabling/disabling of Unconditional Call Forwarding service for All

Callers on the extension.

e

Non-Permanent Call Back – allows PSTN callers registered in the Authorized Phones Database to change the

callback destination for a one-time callback. After the caller hangs up, Quadro will call back to the newly specified

number, but this change will not be logged into Authorized Phones Database.

f

Permanent Call Back – allows PSTN callers registered in the Authorized Phones Database to reconfigure Authorized

Phones Database entries by modifying the caller’s and/or callback numbers. As a result, the caller will be able to initiate

a callback, only by calling from the newly specified caller number.

g

Call Routing Management Menu – allows managing the routing entries in the Call Routing table, i.e. to enable/disable

certain dialing rules by dialing key combinations pre-configured on each routing entry.

h

Quits the Auto Attendant and starts a dial tone.

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 106

Sem comentários

Quadro SW-Version 4.1.x Guia de Instalação Página 100