Quadro Quadro4x Guia de Instalação descarregar pdf (Página 23)

QuadroE1/T1 Manual-I: Installation Guide Configuring the QuadroE1/T1

Editing the E1/T1 Trunk

Select Network as your Interface Type if your QuadroE1/T1 is connected to a PBX, other-

wise choose User.

Next, you are required to enter the Signaling type (CAS or CCS), adjust the correct inter-

face type (E1 or T1), and specify the requested settings of the selected interface type. The

appropriate parameters should be requested from the service provider or in case of connect-

ing to a PBX - according to the settings in the PBX manual.

CAS signaling allows use of the same timeslot both for voice and data transmission. CCS

signaling uses a single timeslot for signaling data transmission for the whole trunk, all other

timeslots are used for voice transmission.

E1, the European system, enables 32 (if CAS is used) or 30 (if CSS is used) timeslots to be

used; T1, the US system, enables 24 timeslots (if CAS is used) and 23 (if CSS is used).

Please Note: Modifying the E1/T1 trunk settings may lead to some broken routes in the Lo-

cal Call Routing Table.

QuadroE1/T1; (SW Version 2.4.x) 22

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 40 41

Sem comentários

Quadro Quadro4x Guia de Instalação Página 23