Quadro Quadro4x Guia de Instalação descarregar pdf (Página 16)

QuadroE1/T1 Manual-I: Installation Guide Configuring the QuadroE1/T1

DHCP Settings for the LAN Interface

If the DHCP server is enabled, the QuadroE1/T1 will assign dynamic IP addresses to the

Admin PC connected to its LAN port.

If you didn’t change the default IP address of the QuadroE1/T1, you may also leave the de-

fault values for IP Address Range. Make sure your connected Admin PC belongs to the

same network as the LAN port of your QuadroE1/T1.

Please Note: Make sure there is only one DHCP server on the LAN. Otherwise, unpredict-

able network behavior can occur.

Click on Next to display the DNS Settings page.

DNS Settings

Select Fixed Nameserver and enter its IP address. If you use your DHCP server and if it will

deliver a DNS server, you may select Dynamically by Provider. When using a static IP ad-

dress, fixed values must be entered.

QuadroE1/T1; (SW Version 2.4.x) 15

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 40 41

Sem comentários

Quadro Quadro4x Guia de Instalação Página 16