Quadro Quadro2x2 Guia de Instalação descarregar pdf (Página 42)

QuadroM 32x/8L/26x/12Li/26xi Manual I: Installation Guide Step 2: Configuring the Quadro

Step 2-B: Using Receptionist

If you wish to use the Receptionist’s features, the Receptionist should be set up on the Qu-

adro. The Quadro’s basic configuration should be done in the same way as described in

the Step 2.

The Receptionist related setup, with detailed instructions on how to configure the Quadro

and the attached IP Phones, is described in the “Receptionist Setup on Quadro” docu-

ment, which you can find at the Epygi’s Web portal.

Step 2-C: Using ISDN Lines

The basic configuration procedure for QuadroM IP PBXs that use ISDN lines is exactly the

same as described in Step 2.

As some ISDN providers require an outgoing MSN to be defined, go to the Telephony

menu and open the ISDN Settings page.

The number of available ISDN trunks is dependent on the type of your Quadro. Qua-

droM26xi and QuadroM12Li have six ISDN trunks.

Fig. I-46:ISDN Trunk Settings page

Before starting the ISDN Trunk configuration, please consult with your ISDN provider ad-

ministrator to receive instructions for which settings are necessary to be configured.

Run the ISDN Wizard for each ISDN trunk to make sure that all settings are proper. To ac-

cess ISDN Wizard, push the appropriate trunk number in the ISDN Trunk Settings table.

The ISDN Wizard – ISDN Settings allows you to choose the interface type and the con-

nection type of the selected trunk(s).

The Interface Type drop down list allows you to select between the User and the Network

interfaces. If the ISDN port of the Quadro is connected to the CO then User interface type

should be selected. If the ISDN port of the Quadro is connected to the PBX then Network

interface type should be selected (in that case Quadro acts as a CO for that PBX).

The Connection Type manipulation radio button group allows you to choose the connec-

tion type for the selected trunk(s):

• PTP (Point to Point)

In case of connection to the CO (User interface type is selected on Quadro) choose

this option if only Quadro is connected to the ISDN trunk from CO (no other ISDN de-

vices are connected to the particular ISDN trunk from CO besides the Quadro).

QuadroM 32x/8L/26x/12Li/26xi; (SW Version 5.2.x) 42

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 75 76

Sem comentários

Quadro Quadro2x2 Guia de Instalação Página 42