Quadro Quadro4xa Guia de Instalação descarregar pdf (Página 23)

Quadro Manual I: Installation Guide Step 2: Configuring the Quadro

Quadro2x, 2xi, Quadro4x, 4xi, 4xa, Quadro16x, 16xi; (SW Version 4.1.x) 23

DHCP Settings for the LAN Interface

If the DHCP server is enabled, the Quadro will automatically assign dynamic IP addresses

to the stations connected to its LAN port.

If you didn’t change the default LAN IP address of the Quadro, you also may leave the de-

fault values for the IP Address Range. Make sure your connected LAN devices belong to

the same network as the LAN port of your Quadro.

Please Note: Make sure there is only one DHCP server on the LAN, otherwise, unpredict-

able network behavior can occur.

Fig. I-18: DHCP Settings for the LAN Interface page

Click on Next to display the Regional Settings page.

Regional Settings

If your Quadro is located outside of the United States, it is important to properly configure

your line connections to the PSTN in your location.

Fig. I-19: Regional Settings page

Proper configuration of Regional Settings is important for the functionality of the voice sub-

system. The Regional Settings determine the proper telephony parameters on the LINE

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 56 57

Sem comentários

Quadro Quadro4xa Guia de Instalação Página 23